df2: Device = gcrdisk.device Unit = 2 Mount = 1 Flags = 0 Surfaces = 2 BlocksPerTrack = 19 Reserved = 2 Interleave = 0 LowCyl = 0 ; HighCyl = 79 Buffers = 20 BufMemType = 3 # /* MountList for V1.3 */ /* Mount Entry for the new Console Handler */ NEWCON: Handler = L:newCon-Handler Priority = 5 StackSize = 1000 # /* This is an example of a non-filing system mount using a handler written in C. */ SPEAK: Handler = L:Speak-Handler Stacksize = 6000 Priority = 5 GlobVec = -1 # /* This is an example of an alternative type of non-filing device mount, used to mount the non-buffered serial handler */ AUX: Handler = L:Aux-Handler Stacksize = 1000 Priority = 5 # /* This is a non-filing system device */ PIPE: Handler = L:Pipe-Handler Stacksize = 6000 Priority = 5 GlobVec = -1 # /* This is an example of a mount list entry for using the recoverable ram disk. Depending on the amount of memory you wish to devote to it, you may want to change the HighCyl value. */ RAD: Device = ramdrive.device Unit = 0 Flags = 0 Surfaces = 2 BlocksPerTrack = 11 Reserved = 2 Interleave = 0 LowCyl = 0 ; HighCyl = 21 Buffers = 5 BufMemType = 1 # /* An example mount entry using the fast file system with a partition of the hard disk using the 2090 disk controller. PREP has been used to create the first partition (up to cylinder 20). The second partition is MOUNTed, using the following entry: NOTE: Some hard disk drivers require more stack than specified here. Some may required less. (The hard disk is not included; this is only an example.) */ FAST: Device = hddisk.device FileSystem = l:FastFileSystem Unit = 1 Flags = 0 Surfaces = 4 BlocksPerTrack = 17 Reserved = 2 Interleave = 0 LowCyl = 21 ; HighCyl = 800 Buffers = 30 GlobVec = -1 BufMemType = 1 Mount = 1 DosType = 0x444F5301 StackSize = 4000 # AUX0: Handler = L:Aux-Handler StackSize = 1000 Priority = 5 # AUX1: Handler = L:Aux-Handler StackSize = 1000 Priority = 5 # PIP: Handler = L:ConHandler StackSize = 600 Priority = 5 GlobVec = 5 # CND: Handler = L:ConHandler StackSize = 1000 GlobVec = 0 #